XYZ Racing Pro Racing Drift Spec Coilovers — BMW X4 F26 4WD (Cancellation Kit for Electronic Damping) 2014-2018

The F26 X4 carries its mass high and feeds drive through xDrive, which is exactly the platform character that makes a committed drift build a deliberate, eyes-open decision rather than a bolt-on. Holding a big angle at speed in a tall, heavy coupe-SAV comes down to keeping the body planted instead of letting it roll onto its outside corner and wash the front. This is where the XYZ Racing Pro Racing Drift Spec coilover for the BMW X4 F26 4WD earns its place.

Built specifically for competitive drifting, this 2014-2018 kit is circuit-focused hardware first and foremost. It also ships with a cancellation kit for the factory electronic damping, so an F26 originally optioned with adaptive dampers runs the new struts cleanly without the control unit logging faults over the removed OE sensors.

What this coilover does for your 2014-2018 BMW X4 F26

Drop the X4 onto its proper ride height with the correct remaining bump stroke and the difference in how the chassis takes a load is immediate: less lean as you commit to angle, a flatter platform when you transition, and a rear end that stays predictable while you manage the slide. The three adjustment knobs let you tune the setup to the surface and the day rather than living with a single fixed compromise. Lowering the centre of gravity tightens up the F26’s naturally upright stance, so weight transfer becomes something you direct instead of something that arrives late. For a heavy 4WD platform being pushed sideways, that composure is the whole point.

About the Pro Racing Drift Spec coilover

This is a coilover engineered around one discipline. The Pro Racing Drift Spec is designed to stabilise the body through high-speed cornering so the driver can set and hold a clean angle, then carry that control into the next transition. Its damping is governed by three adjustment knobs, paired with a small oil-passage design inside the valving. Because that passage is deliberately fine, the oil moving across it over larger bumps can produce a faint noise. That is normal behaviour for this build and not a fault. The product is intended for circuit-track use, where surface imperfections are minimal and the priority is consistent body control under sustained sideways load rather than soft-road absorption.

Fitment for the BMW X4 F26 (2014-2018)

This kit is specified for the BMW X4 F26 4WD, chassis code BM105-C, covering the 2014 to 2018 model years. It is supplied with the cancellation kit needed for cars fitted with the factory electronic damping system, so adaptive-suspension F26s are covered without additional dashboard warnings. Confirm your chassis code and electronic damping option against your build before ordering.

What buyers also search for

• BMW X4 F26 drift coilover setup for competitive angle work
• BMW X4 xDrive suspension that holds body control under hard cornering
• F26 X4 coilover kit with electronic damping cancellation included
• BMW X4 2014-2018 ride-height and damping adjustment for circuit use
• Three-way adjustable coilover for a 4WD BMW X4 build

Specify your ride height and damping preferences and configure yours below.